| Is Part of |
E3S Web of conferences: 12th Nordic symposium on building physics (NSB 2020), Tallinn, Estonia, September 6-9, 2020 / J. Kurnitski and T. Kalamees (eds.).. Les Ulis : EDP Sciences. 2020, vol. 172, art. no. 5009, p. 1-7.. ISSN 2267-1242 |
| Abstract [eng] |
Recently, the construction of external walls of various blocks, which are externally insulated with mineral wool thermal insulation layer, with ventilated air gap and external finishing (ventilated wall structures) is becoming popular for public and office buildings. These blocks are used without internal rendering because they have a good interior surface, stable dimensions, and various filling of masonry joints provide an attractive architectural appearance. This reduces the cost and duration of construction work, however, problems with airtightness of such walls often occur. The air can penetrate through blocks or their joints, and the thermal insulation and wind protection layer does not usually provide the required air tightness of the wall. Currently, there are no standard methods to predict the air tightness of such wall, in practice, samples of particular walls are produced and their air permeability is measured at the laboratories. This is a costly job, which is only suitable for a combination of particular building materials. For the broader use of results of laboratory air permeability measurements, a methodology has been developed to predict the air permeability of block masonry walls using experimentally determined air flow resistances of the individual layers. The masonry from blocks, made of ceramic, expanded clay and aerated concrete with various joints, were used for the research; mineral wool boards of various air permeability were used for thermal insulation and wind protection layer. After measuring the air resistance of masonry units, thermal insulation and wind protection boards, the air flow resistances of the walls of different construction were calculated. The comparison of calculated and measured air permeability of wall samples showed that in cases where the nature of air movement (laminar to turbulent) through a single material remains similar with the nature of air movement through the product incorporated in the structure, the calculation and measurement data differ no more than 12-15%. In structures with building products with very different air permeability properties, especially at high thicknesses of air permeable thermal insulation products, air movement parameters change occurs and calculated and measured results have larger differences. |
